ILX Lightwave LDT-5500B Series User Manual page 35


This chapter is a guide to all of the commands for the LDT-5500B Series
Temperature controller. This chapter is divided into two parts. The first part
contains an overview of the remote commands used by the LDT-5500B Series
Temperature controller. The second part contains all of the LDT-5500B
commands in alphabetical order. Figure 4.1 shows the format for the device
command descriptions in this chapter. The commands that emulate local (front
panel) operation are denoted by "FRONT PANEL" in bold text in the upper right
hand corner of the command description.
Table 4.1 Remote Command Summary Reference List
Name
*IDN?
*RST
CURRENT_LIMIT?
FET_OVER_POWER?
SENSOR_OPEN?
TE_OPEN?
TEC:C1
TEC:C1?
TEC:C2
TEC:C2?
TEC:C3
TEC:C3?
TEC:CAL:ITE
TEC:CAL:SEN
C
OMMAND
Parameters Function
NONE Returns the device identification string
NONE Used to reset the mode and set point values to factory
default values
NONE Used to return the status of the ITE limit error
NONE Used to return the status of the pass elements over
powered error. This error and its reporting is reset when
the output is enabled.
NONE Used to return the status of the sensor open error.
NONE Used to return the status of the sensor open error.
1 Used to enter temperature sensor constant C1
NONE Returns the temperature sensor constant C1
1 Used to enter temperature sensor constant C2
NONE Returns the temperature sensor constant C2
1 Used to enter temperature sensor constant C3
NONE Returns the temperature sensor constant C3
NONE Used to enter the TEC current source calibration mode
NONE Used to enter the sensor calibration mode
4
C H A P T E R
R
EFERENCE
LDT-5500B Series

21