H3C S9500 Series Operation Manual page 171

Operation Manual – Tunneling
H3C S9500 Series Routing Switches
[SwitchA-classifier-1] if-match acl 3000
[SwitchA-classifier-1] quit
[SwitchA] traffic behavior 1
[SwitchA-behavior-1] redirect link-aggregation group 1
[SwitchA] qos policy 1
[SwitchA-qospolicy-1] classifier 1 behavior 1
[SwitchA-qospolicy-1] quit
[SwitchA] qos vlan-policy 1 vlan 10 inbound
2) Configure Switch B.
# Enable IPv6 globally.
[SwitchB] ipv6
# Configure the tunnel destination address on the interface Tunnel 3/0/0.
[SwitchB] vlan 10
[SwitchB-vlan10] port GigabitEthernet 2/1/1
[SwitchB-vlan10] quit
[SwitchB] interface Vlan-interface 10
[SwitchB-Vlan-interface10] ip address 1.1.1.2 24
[SwitchB-Vlan-interface10] quit
# Configure a link aggregation group and set the service type to tunnel on the IPv6
card.
[SwitchB] link-aggregation group 1 mode manual
[SwitchB] link-aggregation group 1 service-type tunnel
[SwitchB] interface GigabitEthernet 3/1/2
[SwitchB-GigabitEthernet3/1/2] stp disable
[SwitchB-GigabitEthernet3/1/2] port link-aggregation group 1
[SwitchB-GigabitEthernet3/1/2] quit
# Create the tunnel interfaces.
[SwitchB] interface Tunnel 3/0/0
[SwitchB-Tunnel3/0/0] tunnel-protocol ipv6-ipv4
[SwitchB-Tunnel3/0/0] ipv6 address 3333::2 64
[SwitchB-Tunnel3/0/0] source Vlan-interface 10
[SwitchB-Tunnel3/0/0] destination 1.1.1.1
[SwitchB-Tunnel3/0/0] aggregation-group 1
# Enable expedite termination on the interface Tunnel 3/0/0.
[SwitchB-Tunnel3/0/0] expediting enable
# Enable RIPng on the interface Tunnel 3/0/0.
[SwitchB-Tunnel3/0/0] quit
[SwitchB] ripng
[SwitchB-ripng-1] import-route direct
Chapter 1 Tunneling Configuration
1-40