Ipv6 Configuration Examples - H3C S9500 Series Operation Manual

Operation Manual – IPv6 Basics
H3C S9500 Series Routing Switches
Clear IPv6 dynamic domain
name cache information
Clear FIB entries from the cache
Clear IPv6 neighbor information
Clear the corresponding PMTU
Clear the statistics of IPv6
packets
Clear all IPv6 TCP connection
statistics
Clear the statistics of all IPv6
UDP packets
Note:
The display dns domain and display dns server commands are the same as those
of IPv4 DNS. For details about the commands, refer to DNS Commands.

1.11 IPv6 Configuration Examples

I. Network requirements
Switch A and Switch B are directly connected through two Ethernet ports that belong to
VLAN 2. Different types of IPv6 addresses are configured for VLAN-interface 2
respectively on Switch A and Switch B to verify the connectivity between two switches.
The IPv6 prefix in the EUI-64 format is 2001::/64, the global unicast address of Switch A
is 3001::1/64, and the global unicast address of Switch B is 3001::2/64.
II. Network diagram
Figure 1-6 Network diagram for IPv6 address configuration
To do...
1-25
Chapter 1 IPv6 Basics Configuration
Use the command...
reset dns ipv6 dynamic-host
reset ipv6 fibcache
{ slot-number | all }
reset ipv6 neighbors { all |
dynamic | interface
interface-type interface-number |
slot slot-number | static }
reset ipv6 pathmtu { all | static |
dynamic}
reset ipv6 statistics [ slot
slot-number ]
reset tcp ipv6 statistics
reset udp ipv6 statistics
Remarks
Available in
user view