Remote Switch Installation; Electrical Box Connection - Majestic DVR33 Installation Instructions & Homeowner's Manual

The gas control is equipped with a captured screw type pres-
sure test point, therefore it is not necessary to provide a 1/8"
test point up stream of the control.
When using copper or ex connectors use only approved t-
tings. Always provide a union when using black iron pipe so
that the gas line can be easily disconnected for burner or fan
servicing, see Fig 5. See the gas specication for pressure
details and ratings.
The replace valve must not be subjected to any test pressures
exceeding 1/2 p.s.i.. Isolate or disconnect this and any other
gas appliance control from the gas line when pressure testing.
R ON/OFF S
EMOTE
Installation
1. Thread the wiring through the holes on the end panels of
the appliance. Take care not to cut the wire or insulation
on metal edges. Route the wire to a conveniently located
receptacle box.
2. Attach the wire to the ON/OFF switch and install the
switch into the receptacle box.
3. Connect the other ends of the wire to the gas control valve
as shown in Fig. 6.
Alternative Switch Location
The remote switch can be installed on the front/side of the
access door. Simply mount the switch to the bracket provided
and screw the bracket to either side of the frame, lining up the
screws with the pre-punched holes, Fig. 7.
Do not wire the remote ON/OFF switch into any
120 volt power supply
10002823/0
WITCH
Fig. 6
Fig. 7
DVR33
Vermont Castings, Majestic Products
EB-1 E
LECTRICAL
The replace, when installed, must be electri-
cally connected and grounded in accordance
with local codes or, in the absence of local
codes, with the current CSA C22.1 Canadian
Electric Code.
For U.S.A. installations follow the local codes
and the national electrical code ANSI/NFPA No
70.
It is strongly recommended that the wiring of
the EB-1 Electrical Junction Box be carried out
by a licensed electrician.
Ensure that the power to the supply line has
been disconnected before commencing this pro-
cedure.
The EB-1 Electrical junction box has been supplied standard
on this model to allow for the easy installation of the optional
fan kits.
To connect the EB-1 box to the house electrical supply follow
the steps below.
1. Unscrew the retaining screw from the EB-1 base plate,
Fig. 8 and remove the EB-1 assembly from the appliance
2. Remove the front cover of the EB-1 box.
3. Remove the plug socket assembly from the EB-1 box.
4. Feed the electrical supply line in through the EB-1 open-
ing in the side of the appliance and then through the back
of the EB-1 assembly.
5. Connect the ground wire of the supply line to the green
screw of the socket assembly.
6. Connect the white wire of the power line to the chrome
screw of the socket assembly.
7. Connect the black wire of the power supply line to the
brass screw (polarized) of the socket assembly.
8. Ret the socket assembly back into the electrical box and
replace the cover plate. Secure the cable with the clamp
on the outside of the EB-1 base plate and ret the EB-1
assembly to the appliance with the retaining screw.
B
OX
Fig. 8
7