Driver Installation - HighSecLabs K304 User Manual

Other Settings
Mouse Speed Setting
Constant mouse cursor speed is essential for system usability.
Having several systems each with a different cursor "ground speed"
is bad for the user. HSL calculates and adjusts the cursor speed
across different displays and computers using the geometry and
display settings entered by the administrator.
In addition, the KM settings include a global speed setting with
input values between 1 and 10 that can be changed to adjust the
cursor speed for all displays. Typical initial setting of cursor speed is
5. After initial use the exact value can be set based on user inputs.
VDT Enabled / Disabled Setting
It is possible through the VDT enabled / disabled setting to disable
the mouse cursor tracking function. Once VDT is disabled – the KM
will enable channel selection only through:
1. Front panel push-buttons;
2. Keyboard shortcuts; and:
3. RDC (if connected)
This setting is enabled by default.
Prevent transition while dragging feature
HSL Secure KM offers a unique feature that further improves
usability – Prevent transition while dragging. When this feature is
enabled, if the user drags an object on one display (while left mouse
key pressed), the cursor would not leave that display.
The following table describes the keyboard shortcuts available on
HSL's K30x:
K304x-K308 Secure KM Switch User Manual
Section 3 - Installation
Key Combination
CTRL | CTRL | F11 | r
CTRL | CTRL | F11 | f
CTRL | CTRL | F11 | U
CTRL | CTRL | F11 | +
CTRL | CTRL | F11 | -
CTRL | CTRL | F11 | d | c
CTRL | CTRL | F12

Driver Installation

To enable proper KM interaction with computers having multiple
head (more than one display), mouse driver software must be
installed. Driver can be loaded from HSL web-site. The driver is
available in EXE file that installs itself at the target computer.
27
Name Description
Reset to Factory Device will reset to factory
defaults
defaults with all settings
and configuration deleted
completely.
Freeze Disable VDT.
between systems will not
be possible via mouse
movement.
Unfreeze Enable VDT.
between systems will be
again possible via mouse
movement.
Increase mouse speed Mouse speed
increased.
Decrease mouse speed Mouse speed
decreased
Setup mode In the next boot after
pressing this
combination the device will
boot into setup
allowing
communicate
configuration utility.
Last loaded Revert to
configuration
externally
configuration
(configuration loaded via
configuration utility).
Switching
Switching
will be
will be
key
mode
him to
with
the last
loaded