Table of Contents
Advertisement
MX8000 Installation and Operation Guide
5.4.4
System Options
In system options you can configure the backup battery
configuration, the receiver ID number, and the normal state
of the auxiliary relay.
5.4.4.1
How to Change Backup Battery Setting
Through system options the backup battery can be configured for the type of backup battery your
installation site requires.
1. Enter program mode. (See Section 5.1.)
1
2. Press
for general options.
4
3. Press
for system options.
4. Press the
or
ENTER
5. Press
.
MENU
To Exit:
Press
until you return to the main menu.
System Options
Menu
Battery Backup Cfg
Receiver Mode
Receiver ID
Bad Data Blocks
Aux Relay Normal
State
Clock Source
5–22
button until the display flashes on the desired setting.
Table 5–9: System Options
Choices
✔
No Battery Bkp
Battery Bkp
DC Bkp
✔
Single
Slave
Master
01-99
01
✔
Strip Bad
Send Bad
✔
Off (De-energized)
On (Energized)
✔
60Hz
50Hz
Int (Internal)
<General Options>
4=System Options
5 Msg Queue Opt.
6 Slave List
Figure 5–8: System Options Display
Default
No charging current applied to battery circuit. Receiver
will not test battery output or give trouble annunciations.
Charging current applied to battery circuit.
No charging current applied to battery circuit. Typically
used for systems that use a UPS (uninterrupted power
supply) for backup battery power.
Receiver is operating independently.
Receiver is a slave to a master receiver.
Receiver is a master.
If this is selected an indicator will be sent to the
automation computer that indicates a bad data block
was received.
Same as Strip Bad except the bad data block is sent
with the indicator.
See Section 5.4.4.5 for auxiliary relay output options.
Synchronize clock to 60Hz Line input.
Synchronize clock to 50Hz Line input.
Synchronize clock to internal crystal.
¯
No Batt Bkp Single
Rcvr ID=01 Strip Bad
AuxRly=Off Clk=60Hz
<Batt Bkp <=Exit>
Comments
Advertisement
Table of Contents
Troubleshooting
