Honeywell ADEMCO MX8000 Installation And Operation Manual page 117

To Change the Ring On Time:
The "On" field controls the ring on time. The ring on time is the length of time the receiver will listen to a
ring prior to recognizing it as a ring.
1. Follow the procedures in Section 5.5.4.
3
2. Press for Line Options menu.
3. Press until the display flashes on the On field.
4. Enter the desired value from the keypad or press the
Values range from 0 to 255 in increments of 50ms (1=50ms, 2=100ms, 3=150ms and so on).
5. When the desired ring on time is flashing press
To Change the Ring Off Time:
The "Off" field controls the ring off time. The ring off time is the length of time the receiver will recognize an
"Off" ring voltage.
1. Follow the procedures in Section 5.5.4.
3
2. Press for Line Options menu.
3. Press until the display flashes on the Off field.
4. Enter the desired value from the keypad or press the
Values range from 0 to 255 in increments of 50ms (1=50ms, 2=100ms, 3=150ms and so on).
5. When the desired ring off time is flashing press
To Select the dB Level:
This option selects the dB level of the handshake and acknowledge tone of the Line Device being
programmed.
1. Follow the procedures in Section 5.5.4.
3
2. Press for Line Options menu.
3. Press until the display flashes on the dB field.
4. Press the or
= -11dBm, Md (Medium) = -10dBm, Hi (High) = -9dBm.
5. When the setting is flashing press
To Change the Ring Threshold Voltage:
The "Threshold" field controls the phone line low voltage/Line Fault threshold level. If the voltage on the
phone line connected to the line card drops below this set threshold level for that Line Device, the receiver
will indicate a Line Fault on that phone line.
1. Follow the procedures in Section 5.5.4.
3
2. Press for Line Options menu.
button to change the dB level of the handshake and acknowledge tone. Lo (Low)
ENTER
or
MENU
or button to change the ring on time.
ENTER
or .
MENU
or button to change the ring off time.
ENTER
or .
MENU
.
Section 5 – Programming
5–61