Honeywell ADEMCO MX8000 Installation And Operation Manual page 119

3. Press until the display flashes on the <Str> field.
ENTER
4. Press .
MENU
5. Enter the desired numeric value from the keypad or press the
characters. (See Table 5–13, page 5–44 for valid programmable string characters.)
6. Press to move to the next character.
or
ENTER
7. Press to enter the PBX string.
MENU
8. Select Y or N by pressing the
Y = Yes, erase or clear the PBX string. N = No, do not clear the PBX string, save the entered value.
Note: If Yes is selected the PBX string will be cleared and the "Clear String" option will revert to N (No).
To Change the Listen-In Timeout:
Timeout is the amount of time Listen-in will remain active before timing out.
Note: This setting will only have an affect if using the common mode. When using the PBX mode, the call is
transferred to another number and the line card drops the call.
1. Follow the procedures in Section 5.5.4.
4
2. Press for Listen In options menu.
3. Press until the display flashes on the <Timeout> field.
4. Enter the desired value from the keypad or press the
setting. Values range from 0 to 255 in 1 second increments.
5. When the desired value is flashing press
To Edit the Listen-In Accounts Lists:
Note: The accounts lists apply to panels that do not send listen-in commands as a part of their message
(Contact ID E606 or SIA LF and LE). Panels that send listen-in commands as part of their message do not
need their account number in an account list.
1. Follow the procedures in Section 5.5.4.
4
2. Press for Listen In options menu.
3. Press until the display flashes on the <Account List> field.
ENTER
4. Press .
MENU
Figure 5–27 shows the next display.
or arrows.
ENTER
.
MENU
Section 5 – Programming
or button to enter any special
or button to change the timeout
5–63