MX8000 Installation and Operation Guide
5. When the desired setting is flashing press
6. To exit press
.
How to Set CID Monitor
Caller ID Monitor allows the selection of different modes for decoding Caller ID. These are:
•
Normal (or standard) where the detection method is first ring, delay, preamble, marks, and then Caller
ID data.
•
Preamble where the Caller ID chip looks for preamble data prior to Caller ID.
•
DTMF where the system looks for DTMF based Caller ID data. (This is a non-standard method of Caller
ID.
•
Marks where the Caller ID chip looks for a Marks signal prior to the Caller ID data.
Note: This option is will only be applicable when Caller ID has been selected.
1. Follow the procedures in Section 5.5.2.
7
2. Press
for Line Gain Opt. menu (see Figure 5–21).
3. Press the
The display Flashes on the Mon= field.
4. Press the
or
5. When the desired setting is flashing press
6. To exit press
.
How to Set CID Gain
Caller ID gain sets the gain of the Caller ID receive logic.
Note: This option is will only be applicable when Caller ID has been selected.
1. Follow the procedures in Section 5.5.2.
7
2. Press
for Line Gain Opt. menu (see Figure 5–21).
3. Press the
The display Flashes on the Gain= field.
4. Press the
or
5. When the desired setting is flashing press
6. To exit press
.
5–52
.
button to change the CID monitor.
.
button to change the CID Gain.
ENTER
.
MENU
ENTER
.
MENU
ENTER
.
MENU