Table of Contents
Advertisement
Adjusting the refrigerator
shelves...
To remove
the shelves:
1. First, remove
food from shelf.
GUIDE STOP
2. Slide shelf straight out to the stop.
3. Lift front, slide shelf the rest of the way out.
SHELF STOP
To replace
the shelves:
1. Fit back of shelf on top of guides
with wire stops
on the bottom
of guides.
2. Lift front, slide shelf in until it clears guide
stops.
SHELF GUIDE
Removing crispers and crisper cover...
-
To remove
the crispers:
1. Slide crisper straight out to the stop, lift front, then
slide the rest of the way out.
2. Replace
in reverse order.
To remove
the cover:
1. Lift front and remove
the cover support.
2. Lift out cover by pulling
up and out.
To replace
the cover:
1. Fit back of cover into notch supports
on walls of
refrigerator,
then lower front into place.
2. Replace
cover support with the long tab toward
the front. NOTE: If the support
needs
adjust-
ment, turn base
right to raise, or left to lower.
LlFl THE FRONT, THEN THE BACK.
PULL OUT TO THE STOP.
HE FRONT AND PULL AGAIN.
Changing the light bulb...
1. Reach behind
the control console
to find bulb
2. Remove
bulb.
3. Replace
with a 40-watt appliance
bulb.
Reversing the door swing...
You can change
the hinges on your refrigerator
so the doors open the other way. You will need a
#20 Torx head screwdriver.
Refer to the instruction
sheet included
with your refrigerator.
Ice cube trays...
(Model
ETISJK only)
If cubes are not used, they may shrrnk. The mov-
ing cold air starts a slow evaporation.
The longer
cubes are stored, the smaller they get.
1. Hold tray at both ends
6
Advertisement
Table of Contents
