Table of Contents
Advertisement
Charge the Reader
Charge the Reader
• Plug the USB charge cable into the Charging Station's USB connector.
• Plug the other end of the USB cable into a USB port on your PC.
• Place the reader into the Charging Station. Be sure that the battery has already been
installed in the reader.
Charging Station with
Embedded Modem
Note: Batteries ship with approximately 50% battery life and must be charged to
100% before first use. Approximate time required to charge a depleted battery is four
hours via USB cable.
Power-on the reader once it is charged to 100% by pulling and holding the trigger for
approximately one second. The reader will beep and vibrate and the LEDs will flash to
indicate that it has been powered on.
Note: Pressing and holding the buttons on the top of the reader will also power it on.
1-4
Charging Station without Embedded
Modem (Accessory Only)
HS-51/HS-51X Wireless Handheld Reader User Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the HS-51 and is the answer not in the manual?
Questions and answers