Installation; Mounting Instructions; Connections - Ovation 214 User Manual

OVATION 214

INSTALLATION

Mounting Instructions

Open the latch and lift the cover. Remove the black caps located on
each of the four mounting holes. Mount the enclosure on the wall
using four screws. Be sure the electrical knockouts are at the bottom
of the enclosure in order to prevent water from entering the control-
ler. Insert the screws in the mounting holes and tighten. Fasten the
four black caps provided with the controller onto the four mounting
holes. The enclosure must be mounted in a location that will allow the
cover to be completely opened right up against the wall.

Connections

To connect the controller, refer to the wiring diagram enclosed with
this user's manual.
Set the voltage switch to the appropriate voltage.
Use the electrical knockouts provided at the bottom of the
enclosure. Do not make additional holes in the enclosure,
particularly on the side of the enclosure when using a com-
puter communications module.
It may be necessary to install a transformer in order to sup-
ply the appropriate voltage to the heating unit.
ALARM CONNECTION: There are two types of alarms on the mar-
ket. One type activates when current is cut off at its input, whereas
the other activates when current is supplied at its input. For an alarm
of the first type, use the NO terminal as shown on the wiring dia-
gram. For an alarm of the second type, use the NC terminal.
ALL WIRING MUST BE DONE BY AN AUTHORIZED ELECTRI-
CIAN AND MUST COMPLY WITH APPLICABLE CODES, LAWS
:$51,1*
AND REGULATIONS. BE SURE POWER IS OFF BEFORE DOING
ANY WIRING TO AVOID ELECTRICAL SHOCKS AND EQUIP-
MENT DAMAGE.
8
OVATION 214 rev.00