Settings - Ovation 214 User Manual

Settings

Manual Control of the Curtain
1
• Set the selection knob to CURTAIN MANUAL MODE. The
status of the manual control mode of the curtain is displayed.
• Use the adjustment knob to select the manual mode status:
"AUt."
"OPn"
"CLo"
"OFF"
Adjusting the Curtain Offset
2
The offset is the number of degrees, above the set point, at which
the curtain starts closing in timer mode (refer to the previous graphic).
It can be adjusted from 0.5 to 20.0°F (0.3 to 11.1°C) and must be
greater than bandwidth 1.
• Set the selection knob to CURTAIN — OFFSET/DEAD BAND.
The curtain offset flashes on the display, alternating with
the letters "OFSEt".
• Use the adjustment knob to set the offset to the desired
value.
to select the automatic control mode;
to manually open the curtain (the letters " OPn"
flash on the display for 5 seconds then the cur-
tain starts opening);
to manually close curtain (the letters "CLO" flash
on the display for 5 seconds then the curtain
starts closing);
to stop the curtain's actuator.
OVATION 214
OVATION 214 rev.00
45