YOYOMOTION YOYOCam G2 User Manual page 9

STEP 3. Set Up YOYOCam
1. Connect the cable from the power adaptor to the power inlet socket on the back panel, as
shown.
2. Plug the power adaptor in to a wall outlet or socket strip.
3. Slide the power switch to the UP position to turn on YOYOCam
4. After approximately 40 seconds, YOYOCam bleeps to indicate that the GSM network has
been found.
5. From your mobile phone send an SMS with text #00# to YOYOCam.
6. YOYOCam confirms your phone as
Master by SMS, Välkommen till
YOYOCam. Lösen är '1234', (Welcome
to YOYOCam. The default password is
1234.) You are now the Master and
have full control over YOYOCam.
7. The SMS responses are in Swedish by
default. Send #127#1# to switch to
English.
8. Network MMS settings are configured
automatically for the major
Scandinavian networks. If your network operator is in the table to the right, you must now
send the command indicated in order to configure MMS. See Mobile Network settings if you
need to manually check or configure MMS.
9. Arm YOYOCam

Send an SMS with text #01# to arm YOYOCam.

Send an SMS with text #02# to disarm YOYOCam.
YOYOCam is now operational.
Network Operator
ACN
Cell Mobile SE
Chess NO
Glocalnet
Halebop
Parlino
Superstar
TDC Song NO
TDC Song SE
Telmore DK
Universal
Ventelo NO
Ventelo SE
9
Command to send
#145#ACN#
#145#CELLMOBILE#
#145#CHESSNO#
#145#GLOCALNET#
#145#HALEBOP#
#145#PARLINO#
#145#SUPERSTAR#
#145#TDCNO#
#145#TDCSE#
#145#TELMORE#
#145#UNIVERSAL#
#145#VENTELONO#
#145#VENTELOSE#