Table of Contents
Advertisement
5. Hang up the call at the landline.
6. Wait 10 seconds.
7. Pick up the Landline:
If you hear dialling tone and can make another call, your line is not blocked.
If you still hear YOYOCam, the incoming call is blocking your landline. This is a property
of your telephone network.
8. Hang up the call again.
9. If your line was blocked, now wait 3 or 5 minutes to see if the landline network disconnects
the call.
10. Pick up the Landline:
If you hear dialling tone and can make another call, your line is now unblocked. You
should only dial this landline if the user has an alternative means of dialling a call, for
example, using a separate mobile phone.
If you still hear YOYOCam, the incoming call is still blocking your landline. You must not
program YOYOCam to dial this line.
Mobile phone networks normally allow the called party to end the call and are therefore emergency
calls to mobile phones should be able to end the call and immediately make a new call.
Note: YOYOCam cannot send MMS images while a voice call is in progress.
To set Voice Dialling mode:
Command:
#39#0#
Response:
Voice call to preset number upon emergency alarm - enabled
SMS/MMS Mode
When the Emergency button
SMS alert followed by an MMS with an image to the Master and each added Emergency number.
SMS Alert:
Alarm from remote control received
To set SMS/MMS mode:
Command:
#39#1#
Response:
SMS and MMS notification upon emergency alarm – enabled
is pressed YOYOCam acknowledges with a bleep, and sends an
36
Advertisement
Table of Contents
