The Rear Ports; Cabling - Telkom ADSL 5102G Instruction Manual

2.4 The Rear Ports

Telkom 5102G
5
Port
Power
1
Switch
PWR
2
3 RESET
LAN
1X-4X
4
(RJ-45
connector)
LINE
5

2.5 Cabling

One of the most common causes of problems is bad cabling or ADSL line(s). Make sure that
all connected devices are turned on. On the front of the product is a bank of LEDs. Verify that
Power ON/OFF switch
Connect the supplied power adapter to this socket.
The moment the device is powered on, press it to reset the
device or restore to factory default settings.
0-3 seconds: reset the device
6 seconds above: restore to factory default settings (this is
used when you can not login to the router, e.g. forgot the
password)
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
four LAN ports when connecting to a PC or an office/home
network of 10Mbps or 100Mbps. You may use a straight or a
crossover cable.
Connect the surge protected ("out") RJ-11 plug of the
integrated surge and power unit into this socket.
4
Meaning
3
2 1
8