The Rear Ports - Telkom Mega 200VWR Quick Start Manual

The Rear Ports

Port
Power Switch
1
PWR
2
3 RESET
LAN
4 1X — 4X
(RJ-45 connector)
Phone
1X
─
5
(RJ-11 connector)
LINE
6
ADSL
7
Antenna
8
Power ON/OFF switch
Connect the supplied power adapter to this jack.
After the device is powered on, press it to reset the device
or restore to factory default settings.
1-3 seconds: reset the device
8 seconds above: restore to factory default settings (this is
used when you can not login to the router, e.g. forgot the
administrative password).
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) (yellow)
to one of the four LAN ports when connecting to a PC or
an office/home network of 10Mbps or 100Mbps.
Connect RJ-11 ("telephone") cable (grey) to this port when
2X
connecting to an analog phone set.
Connect RJ-11 ("telephone") cable (grey) to this port when
connecting to the telephone wall jack.
Connect the supplied RJ-11 ("telephone") cable (grey) to
this port when connecting to the ADSL/telephone network.
Connect the detachable antenna to this port.
Mega 200VWR
Meaning
TLK/200VWR-v1.0-060928
4