Bryant Evolution Connex SYSTXBBECW01 Installation Instructions Manual page 65

the user's internet service provider or mobile device carrier service. Bryant Heating
& Cooling makes no representations or warranties, express or implied, including, to
the extent permitted by applicable law, any implied warranty of merchantability or
fitness for a particular purpose or use, about the compatibility of the user's
computer/network, or mobile device, with the Evolution Connex Control, and/or the
MyEvolution web server, with, and the availability of, the user's internet service
provider or mobile device carrier service, or that the ability to remotely access and
adjust the settings of the Evolution Connex Control will not be negatively affected
by the network- - related modifications, upgrades, or similar activity of the user's
internet service provider or mobile device carrier service.
7.1. Connect Wireless Access Point ot Home LAN
The Wireless Access Point may be located anywhere there is an Ethernet cable
connected to the home LAN router, including next to the router itself. To install
Wi- - Fi connectivity to the Evolution Connex Control, connect the WAN connection
(BLUE port) of the TP- - LINKr Wireless Access Point (supplied with the Evolution
Connex Control Wi- - Fi Bundle) to an open LAN port on the homeowner's existing
router using the provided Ethernet cable.
If there are no open LAN ports available on the homeowner's existing router, the
home router's LAN ports may be expanded by use of an Ethernet Network Switch,
available from a local electronics store. Consult the information supplied with the
network switch for instructions on applying and using the network switch.
The LAN ports on the back of the TP- - LINK Wireless Access Point should not be
used for other devices. The TP- - LINK Wireless Access Point should only be used
for connection of the Evolution Connex Control and is not intended to be used,
wired or wirelessly, with any other devices.
Once the Ethernet cable is connected, install the power supply to the Wireless
Access Point, plug the power supply into a household receptacle, and press the
power button on the back of the Wireless Access Point. The power light on the front
of the Wireless Access Point should light and after a few minutes three other
57