Installing The Side Trim Strips - Viking 100 Series Installation Manual

Enclosure Preparation
T20
A
Make sure you use the correct trim strip since there is a left and a right side strip. The flexible
material should be facing forward (Figure B).
• Adjust the front foot level with the
adjusting wrench to balance and raise the
dishwasher to the enclosure height.
• Adjust the rear foot level with a
screwdriver to balance and raise the
dishwasher to the enclosure height.
NOTICE
• Make sure the dishwasher is plumb
and notice dishwasher can be placed
with a small clearance under the
counter top.
• Turning the screwdriver in the
direction of the black arrows will
bring the dishwasher back feet up.
• Turning the screwdriver in the
direction of the white arrows will take
the dishwasher rear feet down.
NOTICE
11
Installing the
Side Trim Strips
• Remove the
adhesive tape
(Figure A).
• Place the trim
strips on the front
edge of the side
walls (Figure B).
B