Hardwire Conduit Option; Trim Installation Options - Viking Professional & Designer 200 Series Installation Manual

Hardwire Conduit Option

a
Remove any loose items in the dishwasher and carefully lay
the dishwasher on its back. NOTE: Be careful not to pinch
hoses or power cord beneath dishwasher.
c
Loosen ground wire and wires on terminal block.
Loosen strain relief and remove cord.
NOTE: Other items are grounded in this location–these
items must remain grounded.
e
Green
Ground
Connect ground wire.
NOTE: Reinstall front plate and bottom pan.
12
b
Remove bottom pan and front plate.
Black
d
Green White
Ground Common
UL approved
strain relief
Run wires through bottom pan. Using a UL approved
strain relief, connect wires to terminal block.

Trim Installation Options

(not available on all units)
To install dishwasher without trim, remove the 6 screws and washers (3 per
side) and remove trim. To attach wiper gasket to dishwasher, pull protective
film off adhesive back on wiper gaskets and apply to leading edge of
dishwasher frame. Trim gasket to fit.
1a
1b
13