Enclosure Preparation; Electrical Preparation; Preparation For Installing Mounting Brackets; Adjusting Height - Viking 100 Series Installation Manual

Enclosure Preparation

Electrical Preparation

The dishwasher is designed for an electrical supply of 120V, 60Hz, AC, connected to a
dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker rated for
15 amperes.

Preparation for Installing Mounting Brackets

• Place the two mounting brackets into the
top corners of the dishwasher.
• Fix the mounting brackets (A) to the top
corners of the dishwasher, with the screws
supplied.
• Bend sides of mounting brackets (B) in
order to fix from sides (if necessary).
WARNING
WARNING
Dishwasher must be secured to
adjacent cabinetry using the mounting
brackets provided. Failure to do this
may cause damage to property or
bodily injury.

Adjusting Height

If the height of the enclosure is 33-7/8" to
35-7/8" (86.1cm-91.1cm), adjust supports as
shown in the figure.
Supplied (4)
10