Viking 100 Series Installation Manual page 22

Installation
o
A
B
s
If the enclosure height is above 33-1/16"
(84.0cm), use "o" and "p" labeled kickplates
together. Make sure the slotted kickplate (p)
is on the outside so you can adjust height of
the kickplate. Installation should be done
following the steps illustrated in the figures
A, B, and C respectively.
1. Align the kickplate (o) and (p) (A).
2. Secure kickplates to brackets with screws
(t) after adjusting the height of the slotted
kickplate (p) (B).
3. Attach caps (s) as shown in the supply
bags (C).
If the enclosure height is below 33-1/16"
(84.0cm), use only (o) labeled kickplate
(kickplate without slots). Installation should
be done following the steps illustrated in the
Figures A, B, and C respectively.
1. Bend tabs on kickplate (o) inwards (A).
2. Secure kickplate to brackets with screws (t)
as shown in the supply bags (B).
t
3. Attach caps (s) as shown in the supply
bags (C).
C
A
s
21
o
p
B
t
C