Volume (Speaker); Volume (Headphones) - Minelab X-Terra 705 Instruction Manual

36
volume
Volume is the level of sound emitted by the
detector when a target is detected. The Volume
control limits the maximum volume of
target signals.
The sound produced by a distant target starts
softly. As you get closer, the volume level
increases rapidly until it reaches the maximum
level that has been set.
The sound produced by the detector in
Pinpoint or Ground Balance will vary in volume
and pitch depending on the signal strength
(from a target or ground mineralisation). This
volume range is proportional to the maximum
volume setting.
Speaker/Headphone Volume
The X-Terra 705 is able to save separate
settings for both the speaker volume and
headphones volume, switching from one to
the other automatically as the headphones are
connected (Accessories, p. 52).
Set the speaker volume without headphones
connected. Set the headphones volume with
the headphones connected. Use the simple
detecting exercise (p. 16) with different targets
to confirm both the speaker and headphones
volume settings.
When using headphones, it is
recommended that the volume be set
so that a loud target signal will not
damage your hearing.
When the detector battery is low (indicated
by the low battery icon) the speaker volume
limit will be automatically reduced. This saves
battery power and extends detecting time.
You may choose to override this and increase
the volume limit, but you then risk the detector
shutting down sooner.
Press Menu/Select
and choose
Volume .
Use the + and – buttons to adjust the
Volume limit.
Press Pinpoint/Detect
to return to
detection.
Audible Target Response
Volume
=
Target #2
Target #1
Threshold
When Volume and Threshold settings are used
together, there is greater control over target
audio response.
adjusting volume
Audible Target Response
Target #2
Volume
=
Target #1
Threshold
37