Minelab X-Terra 705 Instruction Manual page 29

54
care of your x-terra 705
The X-Terra 705 is a high quality electronic instrument, finely
engineered and packaged in a durable housing. Taking proper
care of your X-Terra 705 is common sense.
The storage temperature of the
X-Terra 705 is –4˚F to 149˚F (–20˚C to +65˚C)
and the operating temperature is 32˚F
to 113˚F (0˚C to 45˚C). Do not leave the
detector in excessive heat or cold for longer
than necessary.
The coil can be submerged in water up
to 20" (0.5m), but the control box is not
waterproof. Although it has been designed
to be weather resistant, it is advisable to
protect the control box in wet conditions.
A protective control box cover is available
(Accessories, p. 52).
Never allow the detector to come into
contact with gasoline or other petroleum-
based liquids.
Keep the detector clean and dry and avoid
getting sand and grit into the shafts or
fastenings (e.g. yoke, twistlocks). Do not use
solvents to clean the detector. Use a damp
cloth with mild soap detergent.
Always remember to turn the detector off
before changing coils.
Coils from other models of Minelab detectors
will not function with the X-Terra 705
(Accessories, p. 52).
Only VFLEX compatible coils will operate
correctly with the X-Terra detectors (Coil
Identification, p. 48).
The display window may be prone to
scratching or damage if not treated with
care. A protective control box cover is
available (Accessories, p. 52).
Ensure that the coil cable is in good
condition and not subject to undue stress,
particularly where it is connected to the coil.
Old, flat, or faulty batteries can cause
many problems with the detector, through
electrolyte leakage. Take the batteries out if
the detector will be unused for more than 1
week. Ensure that only good quality batteries
are used and that they are replaced when
the low battery signal sounds.
Do not use rechargeable Lithium Ion
batteries as their voltage is too high. Non-
rechargeable Lithium batteries may be used.
x-terra 705 specifications
Transmission
Technology
Coil
Visual Display
Audio
Search Mode
Discrimination
Batteries (Not Included)
Padded Armrest
Length Extended
Length Collapsed
Weight (Excluding Batteries)
Optional Accessories
Coil Frequency Options
Detecting Modes
Discrimination Patterns
Iron Mask Discrimination (Prospecting Mode)
All Metal Shortcut
Discrimination Scale (Segments)
Ferrous
Nonferrous
Numeric Range (Target ID Numbers)
Depth Indication Icons
Sensitivity Adjustment
Noise Cancel Channels
Ground Balance Adjustment
Tracking Ground Balance Offset
Pinpoint (Audio & Visual)
Volume Adjustment
Threshold Adjustment
Audio Tones for Target IDs
Low Battery Audio Alarm
User Interface Keys
LCD Icons
Shaft Colour
In the interests of product improvement, Minelab reserves the right to make changes without notice.
Single Frequency Sine Wave
Standard 9" Concentric 7.5 kHz
Transflective LCD with Backlight
Internal Speaker and Headphone Output
Motion Detector
Multi-Segment Accept/Reject/Iron Mask
4 x AA Alkaline/Carbon/Lithium or NiMH/NiCad
4 Position Adjustable with Stand & Armrest
56" (1.42m)
48" (1.22m)
2.9lbs (1.3kg)
Headphones, Skidplates, Environmental Cover,
Accessory Coils, Short Shaft
Model Features
3 (Standard 7.5 kHz, Low 3kHz, High 18.75 kHz)
Coin & Treasure, Prospecting
4 + All Metal
0 to 20
Steps of 2 (-8, -4, -2, 0, 2, 4, 6, 8, 10, 12,
14, 16, 18, 20, 22, 24, 26, 28, 30, 32,
34, 36, 38, 40, 42, 44, 46, 48)
Manual, 1 to 30
Auto or 5 Manual (-2, -1, 0, 1, 2)
Manual 1-90, Auto, Tracking, Beach
–15 to 15
2 Modes (Auto and Sizing)
0 to 30
–5 to 25
1, 2, 3, 4, Multiple
11 + Power
55
VFLEX
28
4
24
5
82
Black