Minelab X-Terra 705 Instruction Manual page 28

52
accessories
The use of headphones while detecting, has
many advantages. They block out external
noise such as wind and traffic, allowing
you to listen more closely to target signals.
Headphones also minimise disturbance to
other people in the area and they extend
battery life.
The X-Terra 705 is able to save separate settings
for both the speaker volume and headphone
volume, switching from one to the other as
soon as the headphones are connected.
(Threshold, p. 34)
(Volume, p. 36)
Connecting Headphones
Always use headphones with a ¼" jack.
Open the rubber headphone cover located
on the left hand side of the control box.
Plug the headphone jack into the socket.
When the detector is turned on, the
headphones icon will appear on the LCD to
indicate that the headphones are connected.
When not using headphones, keep
the rubber cover closed to protect the
control box electronics from moisture
and dust.
Ensure that the headphone volume
does not reach an extremely loud
level. This may increase the risk of
hearing damage.
Short Shaft
A short shaft is available to decrease the length
of the detector.
environmental Cover
Protects the control box from environmental
conditions such as rain and dirt.
Skid plate
A skid plate comes as standard with the
detector. If it wears out from excessive
sweeping along the ground, accessory
skidplates are available for purchase.
Accessory Coils
Are available in different types (Concentric and
Double D), sizes and frequencies. These coils
are suitable for different ground conditions and
specific targets.
To attach an accessory coil:
Turn the detector off using Power
.
Follow the steps of Coil Cable Assembly
(p. 7) and Connecting the Coil (p. 5) in reverse
order to disconnect the coil from
the detector.
Repeat the same steps in the correct order
to connect a different coil.
Turn the detector on using Power .
53