Operation - Omega Altise AVAP10A Instruction Manual

F. MODE: There are 3 mode functions, Normal, Natural or Sleep.
Normal mode:
Natural mode:
Programmed to simulate natural air flow (wind) as it would be if it was
entering via the window. This mode is preferred for use when constant air
flow (Normal mode) is not suitable. Natural mode can be operated HIGH or
MEDIUM or LOW speed.
Sleep Mode:
Programmed to provide comfort while you are asleep. This mode is similar
to the Natural mode and can operate with SPEED mode HIGH or MEDIUM
or LOW.
NOTE: All above can be operate via the remote controller pod shown in Fig.2

OPERATION

1. Ensure that the cap on the water drainage outlet of the unit is tightened. Pour
clean cold water into the water filler area, observing the water level indicator on
the bottom front panel.
CAUTION: DO NOT SPILL OR ALLOW WATER TO COME IN CONTACT WITH
THE CONTROL PANEL
Do not overfill past the MAX water indicator mark.
If desired, place ice in the ice tank in the top of the unit.
CAUTION:
• Do not pour water into the ice tank.
• Do not allow the combined use of water and ice to overfill the water
reservoir.
• When moving the unit, do so with extreme caution, so as not to spill any
water in the reservoir. The unit should be moved slowly and in a sideways
direction.
• Always keep the unit upright.
2. Connect the unit to a power outlet of the same voltage and frequency as
indicated on the rating plate. The unit ON/OFF LED for the power will light up to
indicate that there is power to the unit.
Constant air flow and can be adjusted via pressing the
SPEED function button. Example: Normal LOW or Normal
High or Normal Medium.
6
omega altise