Specifications; Troubleshooting Guide - Snap-On ELECTRIC PRESSURE WASHER Instruction Manual

Problem
Detergent Leak from inside
the unit or won't hold
detergent
Leaking Oil from Pump
Leaking water from
bottom of unit
Spray wand leaks
Detergent Tank fills up with
water
MAXIMUM PRESSURE
MAX WATER FLOW
VOLTAGE
CURRENT
DETERGENT TANK
ELECTRICAL CORD

TROUBLESHOOTING GUIDE

Probable Cause
1. Disconnected or
Kinked Detergent Pick
up Tube.
2. Chemical Tank Nipple
Broken.
1. A small amount of
leakage is normal.
1. Machine Inlet
connection is
defective.
1. Spray wand is not
properly attached.
1. Detergent Suction
Assembly is defective.

SPECIFICATIONS

1650 PSI* / 113.8 bar
1.2 GPM* / 4.5 LPM
120V / 60HZ
12A
0.62 LITER / 0.16 GAL
35 FT. / 10.6 M
24
Solution
1. Call Customer
Service:
1-888-278-8092.
2. Call Customer
Service:
1-888-278-8092.
1. If leakage persists, Call
Customer Service:
1-888-278-8092.
1. Check the Machine
Inlet at the front of the
unit to ensure that
water is not leaking
from it. If the connec-
tion is leaking, it will
have to be replaced.
Call Customer Service:
1-888-278-8092.
1. See instructions.
1. Call Customer Service:
1-888-278-8092.