Snap-On ELECTRIC PRESSURE WASHER Instruction Manual page 21

Problem
Unit will not start (when
trigger is depressed)
AC outlet circuit breaker
trips
TROUBLESHOOTING GUIDE
Probable Cause
5. No AC power at the
outlet.
6. Main voltage supply is
too low.
7. Extension cord is too
long or wire size too
small.
8. Defective ON/OFF
Switch.
9. Defective GFCI Plug.
10. Defective Gun.
1. Circuit (outlet) over-
loaded.
2. Extension cord is too
long or wire size too
small.
3. Nozzle partially
blocked causing
excessive pressure.
20
Solution
5. Main circuit breaker is
tripped or outlet is faulty.
6. Make sure main supply
voltage is adequate
(See specifications).
7. Remove extension cord
or use proper extension
cord (See instructions).
8. Call Customer Service:
1-888-278-8092.
9. Call Customer Service:
1-888-278-8092.
10. Turn off the unit.
Remove the Gun and
Hose assembly from
high pressure outlet in
the back of the unit.
Redirect the outlet to a
safe direction and
switch ON the unit. If
the unit starts and
water comes out of the
front, the Gun may
need to be replaced.
Call Customer Service:
1-888-278-8092.
1. Make sure circuit is
rated at 15 amps or
greater and unit is
plugged into a
dedicated circuit.
2. Use proper extension
cord (see instruc-
tions).
3. Clean Nozzle (see
instructions).