Maintenance - Snap-On ELECTRIC PRESSURE WASHER Instruction Manual

the detergent and reduces its cleaning ability.
7. Allow detergent to "soak in" for 3-5 minutes before washing and rinsing.
Reapply as needed to prevent surface from drying. Do Not allow detergent to
dry on surface (prevents streaking).
TO RINSE:
1. Reset the Pressure Adjust Collar to high pressure, press the trigger and wait for
the detergent to clear.
2. Keep the spray gun a safe distance from the area you plan to spray.
3. Apply a high pressure spray to a small area, and then check the surface for
damage. If no damage is found, it is okay to continue cleaning.
4. Start at the top of the area to be rinsed, working down with same overlapping
strokes as you used for washing and applying detergent.
When you have completed use of the detergent injection system, continue to run in
low pressure position and flush clean water through the detergent tank until it is
thoroughly cleaned.
become clogged and inoperable.
Stop the unit by pressing the ON/OFF button.
Disconnect electrical plug.
Turn off water and depressurize unit by squeezing trigger.
CLEANING TIPS:
• Never leave the Pressure Washer unattended while it is plugged into an electri-
cal outlet and while water is supplied to the equipment.
• Never use the Pressure Washer water inlet to siphon detergent or wax.
• If you have the nozzle too far away from the surface being washed, the cleaning
will not be as effective.
IMPORTANT: DO NOT get closer than 6 inches when cleaning.
Regular maintenance will improve performance and extend life of Pressure Washer.
Pressure Washer's warranty does not cover items that have been subjected to opera-
tor abuse or negligence. Only by maintaining Pressure Washer in accordance with
instructions in this manual will the full value of the warranty be honored.
Wetting the surface first is not recommended, as it dilutes
Failure to clean properly will cause the injection system to

MAINTENANCE

17