Assembly & Setup - Snap-On ELECTRIC PRESSURE WASHER Instruction Manual

This Pressure Washer requires some assembly. If you have any problems with the
assembly of your Pressure Washer, please call the Pressure Washer helpline at
1-888-278-8092. If calling for assistance, please have the model, revision, and seri-
al number from the data tag available.
1. Using a box cutter, cut open the Pressure Washer carton on top.
2. Carefully remove all items from the box and inspect for completeness (see
Functional Description).
WAND/ GUN CONNECTION
Insert the wand into the gun fitting outlet.
Ensure that the threads are aligned properly
and that the connection is secure. Securely
tighten the nut by hand.
PRESSURE HOSE/GUN CONNECTION
PRESSURE HOSE / WASHER CONNECTION
1. Remove and discard the protective plastic plug from the Pressure Hose Connector located
on the rear of unit.
2. Connect the pressure hose plastic
fitting to the Pressure Hose
Connector. Ensure that the threads
are aligned properly and that the
connection is secure. Securely
tighten the nut by hand.
GARDEN HOSE / WASHER CONNECTION
connected and turned on. Damage to equipment resulting from failure to follow
this instruction will void warranty.
ASSEMBLY & SETUP
Unpack the pressure hose and connect
the metal fitting to the gun inlet. Ensure
that the threads are aligned properly
and that the connection is secure.
Securely tighten the nut by hand. Place
the gun into the gun holder on the side
of the Pressure Washer.
DO NOT run the pressure washer without the water supply
12