Snap-On ELECTRIC PRESSURE WASHER Instruction Manual page 23

Problem
No water coming out of
Wand
Unit does not reach
maximum pressure or
pressure is irregular
TROUBLESHOOTING GUIDE
Probable Cause
1. Clogged Nozzle.
2. Wand is attached
incorrectly.
3. Clogged filter.
4. Kink in the Garden
Hose or Hose is
wrapped on a storage
wheel.
5. Gun/Hose Assembly is
defective.
1. Diameter of garden
hose is too small.
2. Water supply is
restricted.
3. Not enough inlet water
supply.
4. Garden Hose length is
too long.
22
Solution
1. Clean Nozzle (See
instructions).
2. See instructions.
3. Clean filter (see
instructions)
4. Unwrap the Garden
Hose and lay it out flat
to ensure that there
are no kinks in the
Hose.
5. Remove Wand from
the Gun and squeeze
trigger to ensure that
the water is coming
out of the front of the
Gun at a rate equal to
the Garden Hose. Call
Customer Service:
1-888-278-8092.
1. Replace with a 5/8
inch or larger garden
hose.
2. Make sure garden
hose has no kinks,
leaks and blockage.
3. Open water source
fully.
4. Shorten the length of
the Garden Hose. We
recommend a maxi-
mum length of 25 to
50 feet for City water
supply and 30 feet for
Well water supply.