Snap-On ELECTRIC PRESSURE WASHER Instruction Manual page 22

Problem
Motor stops suddenly
Unit will not stop when
trigger is released
Unit begins to smoke
Trigger will not move
Gun/Hose - Leaking water
Pump is noisy
TROUBLESHOOTING GUIDE
Probable Cause
1. Extension cord is too
long or wire size too
small.
2. Thermal safety switch
has tripped due to
overheating and over-
work.
1. Gun/Hose Assembly is
defective.
1. Overheated, over-
loaded or damaged
motor.
1. Gun Safety Lock in
engaged.
1. Loose fitting.
1. Pump is sucking air.
21
Solution
1. Remove extension
cord or use proper
extension cord (See
instructions).
2. Make sure main supply
voltage corresponds to
specifications. Allow to
cool and restart unit.
1. Remove Wand from
the Gun and squeeze
trigger to ensure that
the water is coming
out of the front of the
Gun at a rate equal to
the Garden Hose. Call
Customer Service:
1-888-278-8092.
1. Turn off unit and Call
Customer Service:
1-888-278-8092.
1. Release Safety Lock
(See instructions).
1. Tighten fittings. If per-
sists, Gun/Hose will
need to be replaced.
Call Customer Service:
1-888-278-8092.
1. Make sure hoses and
fittings are air tight.
Turn off machine and
purge pump by
squeezing trigger gun
until a steady flow of
water emerges through
the nozzle.