Troubleshooting Guide; Maintenance - Snap-On ELECTRIC PRESSURE WASHER Instruction Manual

2. Set the nozzle to high pressure setting to make
the nozzle hole accessible.
3. Clear blockage in nozzle by inserting the nozzle
cleaning needle (provided) through center hole.
4. After cleaning, remove the needle from nozzle
and store for future use.
LUBRICATION
This Pressure Washer does not require any maintenance on the pump or motor.
Both assemblies are pre-lubricated and sealed, requiring no additional lubrication.
persists or became worse, contact our customer service department.
WATER INLET SCREEN (FILTER)
The Pressure Washer is equipped with a water inlet
screen to protect the pump from foreign debris.
CAREFULLY remove debris from the screen using a
nonabrasive and dull object (finger or Q-Tip). Make sure
screen is not torn or broken.
place. Impurities entering pressure pump can cause internal damage.
COOLING SYSTEM
The air louvers, located in and around the Pressure Washer housing must be kept
clean and free of any obstructions to ensure proper air cooling of the motor and
pump during operation.
Problem
Unit will not start (when
trigger is depressed)
A small amount of oil leakage is normal. If oil leakage
Do not operate Pressure Washer without screen filter in

TROUBLESHOOTING GUIDE

Probable Cause
1. Unit is not turned on.
2. Loose or disconnected
plug.
3. GFCI has tripped.
4. Thermal Switch has
tripped.
19
SCREEN
Solution
1. Press ON/OFF Switch
into ON position.
2. Reconnect Plug.
3. Push reset button on
plug.
4. Allow to cool and
restart unit.