Operating The Pressure Washer - Snap-On ELECTRIC PRESSURE WASHER Instruction Manual

1. Before connecting the garden hose to
the Pressure Washer, connect the gar-
den hose to the water source and run
water through the hose to flush out any
debris. Shut off the water at the source.
2. Attach garden hose to the Pressure
Washer coupling inlet at the lower front of the unit. Ensure that the threads are
aligned properly and that the connection is secure. Securely tighten the nut by
hand.
3. Turn on the water source.
For best result, use a short garden hose (30 ft. or less length),
cold water (less than 100 F) and adequate pressure (no less than 50 PSI).
POWER SUPPLY CONNECTION
KEEP all electrical connections dry and off the ground.
NEVER touch the plug with wet hands.
NEVER cut or remove grounding blade (round longer pin) on
GFCI attachment plug.
1. Connect the Pressure Washer GFCI power cord to a
dedicated electrical outlet.
2. Press the RESET button on the GFCI to ensure its
proper operation.

OPERATING THE PRESSURE WASHER

Outlet capacity must be 120V, 60HZ and minimum 15 AMP.
13
2
3