Proper Care & Cleaning - Glacial 75IECHK-SC-SP User Manual

Hot, room and cold bottled water cooler
Table of Contents

Advertisement

PROPER CARE & CLEANING
General Cleaning
Perform: As needed
Time Required: 5 minutes.
Note: Do NOT use abrasive materials or chemical cleaners.
1. Clean cabinet surfaces with a soft cloth and warm soapy water, then rinse.
2. Wipe dust from back of dispenser to improve efficiency.
3. Remove drip tray assembly by pulling it forward. Remove cover. Place tray and cover in
dishwasher or wipe parts clean with a soft cloth and warm soapy water.
Cleaning Cold Reservoir and Water Lines
Perform: Every 3 months or whenever any of taste occurs.
Time Required: 15 minutes.
Note: Best to do prior to loading a fresh bottle.
1. Turn energy saving switch OFF.
2. Unplug power cord from wall outlet.
3. Remove water bottle.
4. Unclip Wall Mount Strap from back of dispenser and turn dispenser around so backside is
facing away from the wall.
5. Place a 2 gallon or larger bucket under the drain plug in the rear
of the dispenser.
CAUTION
Remove drain cap and silicon plug. Cold water will immediately
flow into the bucket. This will be followed several seconds later by
hot water at temperatures that can cause severe burns. Avoid
direct contact with hot water. Keep children and pets away while
draining unit.
Reminder - Place drain cap and silicon plug in a safe location so
they are not lost.
6. Once unit has completed draining replace drain cap and silicone
plug.
7. Remove remaining water from cold reservoir by dispensing from both taps into a pitcher.
8. Remove bottle receptacle or collar by turning it counter clockwise and pulling up. Store in a
safe place.
9. Remove plastic baffle from inside reservoir.
10. Clean bottle receptacle and baffle with a soft cloth using a mixture of one gallon tap water
and 1 tablespoons unscented household bleach, then rinse.
Model # 75IECHK-SC-SP :Page 9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents