Glacial 75IECHK-SC-SP User Manual page 8

1. Remove tamper seal from bottle cap. Do NOT remove plastic cap.
2. Clean bottle cap and neck with a soft cloth and warm soapy water, then rinse.
3. Lift bottle and insert onto the probe. Apply slight pressure until the plug inside the cap pushes
in and the bottle is seated. Water will begin to flow into the reservoirs causing air bubbles to
form in the bottle.
4. Plug cord into a properly grounded wall outlet.
5. Turn energy saving switch on back of dispenser to ON. This switch controls the heating of
water. If you do not want hot water, turn this switch OFF.
Initial Rinsing of Water Lines
This unit has been tested and sanitized prior to packing and shipping. During transit dust and
odors can accumulate in the tank and lines. You must dispense and dispose at least one quart
of water prior to drinking any water.
Dispense Cold Water
Note: After setup, it will take 1 hour to get water to maximum cold temperature. During this time
the compressor will run continuously. This is normal.
1. Position bottle, glass, pitcher or cooking pot securely below cold water tap.
-The circular shapes in the drip plate help align the flow of water. This unit dispenses water at
a fast rate. To avoid splashes, hold cup as close to the tap as possible.
2. Depress cold water control downward to start flow.
3. Release cold water control once desired fill level is achieved.
Dispense Hot Water
CAUTION
This unit dispenses water at temperatures that can cause severe burns. Avoid direct contact
with hot water. Keep children and pets away from unit while dispensing. Never allow children to
dispense hot water without proper and direct supervision. Unplug unit to prevent unsupervised
use by children.
Note: After setup, hot water will be available in 15-20 minutes.
1. Position bottle, glass, pitcher or cooking pot securely below hot water tap.
-The circular shapes in the drip plate help align the flow of water. This unit dispenses water at
a fast rate. To avoid splashes, hold cup as close to the tap as possible.
2. Push red hot water release inward and depress hot water control downward to start flow.
3. Release hot water control once desired fill level is achieved.
Replace an Empty Bottle
Notice: Replace bottle as soon as you notice it is empty.
1. Lift bottle straight up to disengage from the bottle probe.
2. Remove tamper seal from top of bottle cap of fresh bottle. Do NOT remove plastic cap.
3. Lift bottle and insert onto the probe. Apply slight pressure until the plug inside the cap pushes
in and the bottle is seated. Water will begin to flow into the reservoirs causing air bubbles in
the bottle.
Model # 75IECHK-SC-SP :Page 8