JAI AM-800CL User Manual page 64

Black level
LUT
Gamma
Flat Field Compensation
Blemish Compensation (Bright)
Color interpolation
Test pattern
Temperature sensor
Serial communication
Power
Lens mount
Flange back
Sensor alignment
Optical filter
Operating temperature
Humidity
Storage temp/humidity
Vibration
Shock
Regulatory
C-mount
Size
F-mount
C-mount
Weight
F-mount
Note1): Approximately 5 minutes pre-heating is required to get the mentioned specifications.
Note2): The above specifications are subject to change without notice.
AM-800CL / AB-800CL
-256 LSB to 255 LSB can be changed, 1 step is 0.25dB
OFF: γ=1.0, ON= 256 points can be set
0.45 to 1.0 can be set, Adjusting step is 0.05
Compensated by 128 x 128 pixels block
maximum 64 pixels for dark and bright compensation per 1 tap
(note: black compensation is only by factory preset)
-
OFF/Black-white/Gray H-ramp/
Gray V-ramp/white(100%)
-55 to +125ºC (measuring range), resolution is 0.0625ºC
DC+12V to +24V ± 10%, 7.8W (at normal operation, DC+12V)
The rear protrusion on C mount lens must be less than 10mm.
The rear protrusion on F mount lens must be less than 12mm
C mount : 17.526 mm, tolerance 0 to -0.05 mm
F mount :
X and Y axis: ± 0.1 mm ( at center)
- Protection glass only
-25C to +60C/20% to 80 % non-condensing
CE (EN61000-6-2 and EN61000-6-3), FCC part 15 class B, RoHS, WEEE
- 62 -
32 LSB at 10-bit output,
(at 10-bit output)
Built in,
3 x 3 interpolation matrix
OFF/Color bar/Gray H-ramp /
Gray V-ramp /White(100%)
Camera Link or Hirose 12-pin
C mount or F mount
46.5 mm, tolerance 0 to -0.05 mm
Optical low pass filter
-5C to +50C
20 – 80% non-condensing
10G (20Hz to 200Hz, XYZ)
70G
55 x 55 x 69 mm (W x H x D)
55 x 55 x 98 mm (W x H x D)
280g
340g,