Maintenance - ElectrIQ AIRCUBE 10DLX User Manual

2.1 Remove the water plug
2.2 Use a water pipe to connect to the water outlet.
2.3 You can plumb this pipe into your current plumbing system, lead it outside or
use a water pump.
Note
When the unit is in the cooling function, it is recommended not to have the drain pipe installed. Please
make sure that the rubber cap is in place when the unit is running.
When operating the heating function, the low rubber cap
install a proper drain pipe in order to improve the heating effect
When operating the dehumidifying function the unit must be used with a drain hose.
Please remove the air exhaust hose, connect a drain hose to the drain hole and lead the water to
the outside in order to intensify dehumidifying capacity.
When the water tank is full,"E4" will be displayed on the display panel. Please remove the rubber
cap of the drain port to drain out the water first. After the drainage is completed, please restart the
unit and then the unit can operate normally.
Cleaning
Please shut off the unit and unplug from the mains before cleaning or performing
any maintenance
Clean the surface
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage.
Air filter cleaning
a) Clean the air filters every 2 weeks. If the air filter is blocked with dust, the unit's
performance will be significantly affected.
b) Pull out the top and bottom filters as pictured below
c)
Wash the air filters by immersing them in warm (about 40° C) water with a neutral
detergent.
d)
Rinse it and then dry it thoroughly.
e) Carefully re-install air filters

Maintenance

Open from here
Page 10 of 13
on drain port should be pulled out and