Immobilizer Harness Wire Connec; Tion Guide; Immobilizer Harness Wiring - Clifford AvantGuard 5.1 Installation Manual

h2/8 pink/black (-) accessory output C (200mA)
This wire produces a 200mA output when activated by the remote control and can be
used to operate a variety of accessories. All accessory outputs can be programmed to
different types of outputs. Please see Note #6 in the programming notes section of this
guide.
h2/9 yellow/white (-) horn honk output (200mA)
This wire is a low current output (200mA) for the horn to sound when the system has
been violated.
h2/10 brown/red brake light (+) 12V input
This is the polarity source for the brake light output and must be 12 volt constant.
h2/11 brown/white brake light input/output
This wire powers the brake light circuit with the 12 volt circuit only on H2/10 when
activated. If this wire is used it is not necessary to connect the blue/white H1/11
brake input wire to the Intellistart module.
h2/12 blue/white second unlock output (200mA)
This wire produces a (-) 200mA output for progressive locks in which the driver door
unlocks first and the remaining locks unlock with a second press of the unlock button.
immobilizer harness wire connection guide

immobilizer harness wiring

Locate the ignition and starter wires using a multimeter. Cut the appropriate wire and
attach the key side and car side wires to the corresponding wires on the four-pin
immobilizer harness.
© 2006 directed electronics—all rights reserved
Starter Side
Starter Key Side
Starter
x
CUT
Ignition
x
CUT
Ignition Car Side
Ignition Key Side
9