Immobilizer Harness Wire Connection Guide; Immobilizer Harness Wiring Diagram; Immobilizer Harness Wiring Guide - Clifford Arrow 5.1 Installation Manual

immobilizer harness wire connection guide

immobilizer harness wiring diagram

___
BLACK
H2/1
___
BLACK
H2/2
___
BLACK
H2/3

immobilizer harness wiring guide

h2/1, h2/2, and h2/3 black immobilizer pigtail harness
The starter immobilizer harness can be installed as a normally open or normally
closed circuit by connecting the desired side of the three-wire immobilizer. Locate the
starter wire, then cut it and make connections as described in the following diagram.
Connect H2/1 to the end of the wire that is still connected to the ignition switch; con-
nect H2/2 or H2/3 to the end of the wire that continues to the vehicle's starter circuit.
N N O O T T E E : : Factory settings is normally closed if wired for normally open you must change
the programming.
NOT USED (87)
NORMALLY CLOSED (87A)
COMMON (30)
IMMOBILIZER
© 2006 directed electronics
Starter - Normally Closed (Motorside)
NORMALLY
CLOSED
ON BOARD
Starter - Common (Keyside)
Starter - Normally Open (Motorside)
NORMALLY
OPEN
NORMALLY OPEN (87)
NOT USED (87A)
COMMON (30)
ON BOARD
IMMOBILIZER
9