Warning! Safety First - Clifford AvantGuard 5.1 Installation Manual

warning! safety first

The following safety warnings must be observed at all times:
Due to the complexity of this system, installation of this product must only be per-
formed by an authorized Clifford dealer.
When properly installed, this system can start the vehicle via a command signal
from the remote control transmitter. Therefore, never operate the system in an
area that does not have adequate ventilation. The following precautions are the
sole responsibility of the user; however, authorized Clifford dealers should make
the following recommendations to all users of this system:
1. Never operate the system in an enclosed or partially enclosed area without
ventilation (such as a garage).
2. When parking in an enclosed or partially enclosed area or when having
the vehicle serviced, the remote start system must be disabled using the
installed toggle switch.
3. It is the user's sole responsibility to properly handle and keep out of reach
from children all remote control transmitters to assure that the system does
not unintentionally remote start the vehicle.
4. THE USER MUST INSTALL A CARBON MONOXIDE DETECTOR IN OR
ABOUT THE LIVING AREA ADJACENT TO THE VEHICLE. ALL DOORS
LEADING FROM ADJACENT LIVING AREAS TO THE ENCLOSED OR
PARTIALLY ENCLOSED VEHICLE STORAGE AREA MUST AT ALL TIMES
REMAIN CLOSED.
Use of this product in a manner contrary to its intended mode of operation may
result in property damage, personal injury, or death. Except when performing
the Safety Check outlined in this installation guide, (1) Never remotely start the
vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the
keys in the ignition. The user will be responsible for having the neutral safety fea-
ture of the vehicle periodically checked, wherein the vehicle must not remotely
start while the car is in gear. This testing should be performed by an authorized
Clifford dealer in accordance with the Safety Check outlined in this product
installation guide. If the vehicle starts in gear, cease remote start operation imme-
diately and consult with the user to fix the problem immediately.
After the remote start module has been installed, test the remote start module in
accordance with the Safety Check outlined in this installation guide. If the vehi-
cle starts when performing the Neutral Safety Shutdown Circuit test, the remote
start unit has not been properly installed. The remote start module must be
removed or properly reinstalled so that the vehicle does not start in gear. All
installations must be performed by an authorized Clifford dealer.
© 2006 directed electronics—all rights reserved
1