Programming Notes - Clifford AvantGuard 5.1 Installation Manual

horn output - pulsed/latched
Pulsed: H2/9 YELLOW/WHITE wire will generate a pulsing (-) output when the
alarm is in full trigger. When arming and disarming the output does not operate.
Latched: H2/9 YELLOW/WHITE wire will generate a constant (-) output when the
alarm is in full trigger. When arming and disarming the output will pulse as per
the standard chirp pulses.
auto immobilization - off/on
Off: Turns the auto immobilization feature off.
On: Turns the auto immobilization feature on.

programming notes

Note #1: Adding a new transmitter in auto-learn configuration.
Press the arm/disarm button of the Radar 2 remote control; the siren will chirp
to confirm the transmitter has been learned.
Note #2: Adding a new transmitter in custom-configuration.
For the arm/disarm channel, transmit the channel of the new three, four, or five but-
ton transmitter that you want to control that feature; the siren will then chirp once.
For the rest of the channels, press the desired button on the remote to do the
specified feature.
N N O O T T E E : : When programming a new transmitter to custom configuration, an arm/dis-
arm channel must first be programmed before programming the remaining channels.
Note #3: Selecting siren sounds.
After entering this feature, press the arm/disarm button. The siren will generate a five-
second sample of each available siren sound. Perform the following steps to add or
delete that specific sound.
Add sound: Press
sound to add that sound.
Delete sound: Press
desired sound to delete that sound.
Note #4: RPM programming.
Drive the vehicle to an open area and allow the engine to warm up until the
engine RPM drops to normal idle speed.
Place the engine in park or neutral and set the parking brake.
© 2006 directed electronics—all rights reserved
on the PlainView 2 Valet switch while playing the desired
on the PlainView 2 Valet switch while playing the
47