V-ZUG Combi-Steam SL Operating Instructions Manual page 71

... Descaling
Descaling
The appliance must be switched off. The appliance door must be
closed when descaling is being carried out. Burns hazard! For
safety reasons, once started the descaling process cannot be
aborted.
A Press the
A
Turn the
A
Press the
– «Descale» «Descale appliance» appears in the plain text display.
A
Press the
– «Descale appliance» «start» appears in the plain text display.
A
Press the
– «Add 0.5 l descaler» «and press OK» appears in the plain text display.
A Pour the entire contents of the special descaler undiluted into the water
tank.
A
Slot the water tank into position in the water tank compartment.
A
Press the
– The descaling phase starts.
– «Descale appliance» «running» appears in the plain text display.
After about 30 minutes, «Pour away descaler» «Add 1.2 l water» appears in
the plain text display.
A
Remove the water tank, pour away the descaler and fill the tank with 1,2 l
cold water.
A
Put the water tank back.
– The rinsing phase starts automatically.
– «Descale appliance» «1st rinsing cycle» appears in the plain text display.
Whether further rinsing cycles are required depends on the level of
soiling of the liquid being pumped off.
– In this case, «Descale appliance» «Repeat 1st rinsing cycle» ap-
pears in the plain text display.
adjusting knob to activate the plain text display.
adjusting knob until «Descale» appears.
adjusting knob to confirm.
adjusting knob to confirm.
adjusting knob to confirm.
adjusting knob to confirm.
71