Table of Contents
Advertisement
Sys tem Check list & Trou ble shoot ing (Con tin ued)
Step 10. (Continued)
Test the door trig ger cir cuit.
n Siren does not sound immediately. If the alarm does not sound im me di ate ly when one
of the doors is opened, make sure that that door's pin switch is work ing prop erly and,
when open, is con sis tently show ing less than 1.5 volts if the ve hi cle has
negative- switching door trig gers or more than +11 volts if the ve hi cle has
positive- switching door trig gers, also make sure the pin switch is connected to the
correct wire. If not, then the door pin switch (or pin switches) is ei ther de fec tive or in
need of clean ing.
Step 11.
Test the trunk trig ger cir cuit.
Arm the system, then use the key to unlock the trunk.
n Si ren sounds im me di ate ly, parking lights flash re peat edly. This is the correct
response, proceed to step 12. (You can silence the siren by press ing the button on the
re mote con trol once or disarm by pressing the button twice.)
n Alarm does not sound immediately. If the alarm does not sound im me di ate ly, make
sure that the trunk pin switch is work ing prop erly and, when open, is con sis tently
show ing less than 1.5 volts. Also make sure the trunk pin switch is connected to the
correct wire. If not, the trunk pin switch must be thor oughly cleaned or re placed, or
polarity may need to be inverted.
Step 12.
Test the hood trig ger circuit.
Arm the system, then open the hood. The following should occur:
n Si ren sounds im me di ate ly, parking lights flash re peat edly. This is the correct
response, proceed to step 11. (You can silence the siren by press ing the
the re mote con trol once or disarm by pressing the button twice.)
n Alarm does not sound immediately. If the alarm does not sound im me di ate ly, make
sure that the hood pin switch is work ing prop erly and, when open, is con sis tently
show ing less than 1.5 volts. If not, the hood pin switch must be thor oughly cleaned or
re placed, or polarity may need to be inverted.
Step 13.
Test the AutoArming fea ture.
Turn the ignition "ON" and let the car idle for a minimum of 10 seconds. Turn the ignition
"OFF," then open and close the door. Wait five seconds.
n Parking lights flash twice. 25 seconds later, the vehicle arms passively as indicated by
a rapidly flashing LED. This is the correct response, proceed to step 14.
n System does not passively arm.
§ Make sure that Instant AutoArming has been turned on using the programming
instructions on page 14.
§ Verify the door trigger and ignition connections.
Step 14.
Test the AutoArming By pass fea ture.
Disarm the system. Turn the ignition to the "ON" position, then turn the ignition "OFF."
n One Chirp. This is the correct response, wait 30 seconds after the optional courtesy
lights have turned off to insure the system does not passively arm. Proceed to step 15.
21
button on
Advertisement
Table of Contents
