High Out Put Si Ren; Hood Trig Ger; Fi Nal Wir Ing Con Nec Tions; Smart Powe Rup 2 - Clifford Polaris 4 Installation Manual

Mobile security/convenience system

Hide thumbs Also See for Polaris 4:

Owner's manual (9 pages)

Table Of Contents

Table of Contents

Pas sen ger Com part ment Con nec tions (Con tin ued)

Starter or Ig ni tion Im mo bi li za tion Cir cuit (Con tin ued)

To in ter rupt the starter cir cuit:

1. Use a voltmeter to locate the one wire that carries +12V during the cranking cycle

ONLY.

2. Cut this wire, then try to start the engine. It should not crank.

3. Con nect the WHITE/RED wire to the key side of the cut starter line.

4. Connect the other WHITE/RED wire to the starter side of the cut starter line.

5. Locate the ignition switch wireloom under the dash and use a voltmeter to locate the one

wire that carries +12V throughout BOTH the cranking and engine running cycles, and

0 volts when the ignition is off.

6. Connect the WHITE/BROWN wire to this wire.

Mount the siren in the engine compartment away from hot or moving parts and where it

cannot be reached from under the vehicle, preferably opposite the exhaust system. Point the

siren down to avoid water collection.

1. You must firmly secure the siren to the engine bay firewall or an inner wing using all three

sheet metal screws supplied.

2. Us ing the sup plied con nec tor, connect the wireloom's YELLOW wire to the BLACK siren

wire.

3. Connect the RED wire through the 5A fuse coming from the battery positive cable clamp,

as indicated in the diagram on page 4.

Vehicles with negative switching hood light will interface directly with the Polaris 4 (on positive

switching Rolls-Royce vehicles, use a relay to invert polarity). The switch may be located in or

near the hood latch or at the hood light. If a switch cannot be located, you must add a pin

switch in a location away from water channels.

1. Connect the GRAY/YELLOW wire to the hood switch.

1. Connect the RED wire to the 5A fuseholder as shown on page 4.

2. Connect the RED/WHITE wire to the 20A fuseholder as shown on page 4.

3. Attach the two fuseholders to the battery positive cable clamp.

4. Attach the BLACK wire to the vehicle battery negative cable clamp.

NOTE: Power and test ac ces so ries af ter the ba sic sys tem has been tested.

In di vidu ally fuse all ac ces sory power con nec tions. In di vidu ally fuse all +12V

con nec tions.

SmartPowerUp 2 ensures that the system powers up in the same state (disarmed, armed or valet

mode) it was last in. When you first power up the system, it will silently enter its disarmed state.