Changing The Monitor Settings With The Contact Sensors Of The Control Panel - Fujitsu B27T-7 Operating Manual

Changing the monitor settings with the contact
sensors of the control panel
With the OSD menu not activated, you can make the following settings directly.
Call up OSD menu
MENU
Activate/deactivate ECO operating mode
ECO
Select input signal (digital/analog)
INPUT
Adjust volume
Adjust brightness
Perform auto-adjustment of the monitor with analog input
AUTO
Contact sensor for the on/off switch
Select OSD language
After the first switch on and after the monitor has been reset to the factory settings,
the selection screen for the language appears:
► Touch the ECO
► Touch the
MENU
After selecting the OSD language for the first time, you can change
it at any time in the OSD.
Activate/deactivate ECO operating mode
The power consumption of the device can be decreased by reducing
the brightness of the picture.
► Touch the ECO

The message ECO Mode on or ECO Mode off is displayed.
If the ECO operating mode is activated, the following OSD settings are changed:
Colour
Brightness
After the ECO operating mode is switched off, the brightness previously set by the user is restored.
Fujitsu
or INPUT sensor to select the desired language.
sensor to confirm or the
sensor to switch the ECO operating mode on or off.
6500 K
reduced
sensor to cancel.
AUTO
Operation
21