Locking The Osd Menu - Fujitsu B27T-7 Operating Manual

Operation
Selecting the input signal (D-SUB/DVI-D/DisplayPort)
► Touch the INPUT
► Touch the ECO
connection (VGA, DVI or DisplayPort).
► Touch the MENU
This setting window can also be called up when the OSD menu is locked.
Performing auto-adjustment of the monitor
This setting is only possible with an analogue VGA input.
► Touch the
AUTO

The Auto Processing message appears.
Picture quality and position are set to optimum values for your system.
Locking the sensor for the on/off switch
The sensor for the ON/OFF switch can be locked to prevent accidental or
unauthorised changes to the monitor settings.
► Touch the ECO

The message Power button locked / unlocked is displayed.
Please proceed in the same manner to release the locked sensor
for the ON/OFF switch again.

Locking the OSD menu

The OSD menu can be locked to prevent accidental or unauthorised changes to the monitor settings.
► Touch the MENU
simultaneously for several seconds.

The message OSD locked and a progress bar appear.
► To activate the lock function, touch both sensors until the progress bar is fully loaded.

The OSD menu is locked.
Please proceed in the same manner to release the locked OSD menu again.
22
sensor to open the Input select setting window.
or INPUT sensor to select the desired monitor
sensor to confirm or the
sensor for about 1 second.
sensors at the same time for a few seconds.
and INPUT
sensor and the sensor for the ON/OFF switch
AUTO sensor to cancel.
Fujitsu