Technical Specifications; Conformity Certificates - Husqvarna 4000 Operator's Manual

Weight and Dimensions 4000
Weight – dry
Weight with gasoline and oil full
Length
Width
Height
Blade
Material cut
Blade type
Blade rotation
Blade shaft speed
Cutting depth
Cutting distance from wall
Average cutting rate - Estimate only. Speed will vary with job conditions and concrete mixes.
Soft aggregates
Medium aggregates
Hard aggregates
Blades are available in 13.5 inch (343 mm) and 12 inch (305 mm) diameters and in 0.100 inch (2.5 mm),
0.250 inch (6.4 mm), 0.380 inch (9.7 mm), and 0.500 inch (12.7 mm) widths
Engine:
Engine oil volume
Gasoline tank volume
Type
Air filter
Oil system
Muffler
Emissions
Cooling
Cylinder
Controls
CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road
Ap plication as relating to CARB standards. Under construction equipment, and in particular, as a Saws :
concrete, masonry, cutoff, with engine power less than 19KW (25hp), CARB standards do not apply to this
machine.
For more information see the website http://www.arb.ca.gov/msprog/offroad/preempt.htm

TECHNICAL SPECIFICATIONS

CONFORMITY CERTIFICATES

15
440 lbs 200 kg
454 lbs 206 kg
61 inch 1549 mm
28 inch 711 mm
38 inch 965 mm
Green concrete only
13.5" (343 mm) or 12.0" (305 mm) dry cut with tri-arbor
Counter clockwise, upcutting
3500 rpm
3 inch maximum (76 mm) depending on blade size and
amount of blade wear
3 1/2 inch 89 mm
3 inch (76 mm) depth
14 ft/min (4.3 m/min)
11 ft/min (3.4 m/min)
7 ft/min (2.1 m/min)
Kohler Command Pro CH18S
2 quarts 1.9 liters
4.5 gal 17 liters
Air cooled, 4-cycle, twin cylinder, hydraulic overhead
valves, gasoline engine
Dual element construction duty
Full pressure lubrication with spin-on oil filter
Low noise, front exhaust
Complies with EPA Phase 2 and CARB Tier II USA
regulations
Air cooled
Aluminum with cast iron liner
Engine mounted manual throttle and choke levers,
manual on/off switch
2 inch (51 mm) depth
24 ft/min (7.3 m/min)
17 ft/min (5.2 m/min)
9 ft/min (2.7 m/mim)