Moving By Hand - Husqvarna Z4818BIA/968999250 Operator's Manual

Moving by Hand

WARNING!
Make no adjustments without:
- the engine stopped,
- the ignition key removed,
- the parking brake activated.
When pushing or pulling the mower, be sure
to engage the IZT (Integraded Zeroturn
Transaxle) bypass linkages. The IZT bypass
linkages are located on the rear of the frame,
below the rear engine guard.
• Raise the deck into the highest cutting
position.
• Pull the IZT bypass linkages out and into
the slots and release so that it is held in
the bypass position.
• To reengage the IZT's to drive, reverse
the above procedure.
34
English-
OPERATION
1. IZT Bypass linkage
Bypass linkages
1. Head outside of rear deck
2. IZT Bypass linkage in bypass position
Bypass position
CZ10
1
2
CZ12