Moving Machine By Hand - Husqvarna RZ4623 Operator's Manual

Moving Machine By Hand

When pushing or pulling the mower, engage the
EZT bypass linkages. The EZT bypass linkages are
located on the rear of the frame, below the rear engine
guard.
1. Raise the deck into the highest cutting
position.
2. Engage the parking brake.
3. Pull the EZT bypass linkages up and out of
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
4. To reengage the EZT's to drive, reverse the
above procedure.
Load the machine into truck or trailer by driving slowly
up the ramps. DO NOT LIFT! The machine is not
intended to be lifted by hand.
WARNING!
Bypass linkages are located close
to the muffler. To prevent burns, the
engine should be shut off and allowed
to cool before the bypass linkage
levers are handled.
WARNING!
Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the parking brake activated
WARNING!
Use extreme caution when loading the
machine into a truck or trailer using
ramps. There is the possibility of
serious injury or death if the machine
falls off the ramps.
34
OPERATION
Left side bypass linkage, EZT engaged
Left side bypass linkage, EZT locked in the bypass position
8058-032
8058-033